Handheld laser: SUP20S/C/T reflecting mirror replacement

English version

注意：

Note:

1.更换时请注意现场环境，建议拆掉在办公室等相对环境较好的地方更换

1. Please be aware of the site environment when replacing, it is recommended to do so in a relatively good environment such as an office

2.安装时轻拿轻放，注意安装时的水平放置

2. Handle gently when installing and pay attention to horizontal placement when installing

步骤

Steps

1.拆掉侧盖板，拔掉端子

1. Remove the side cover plate and unplug the terminals

2.如图位置，松开机米螺丝，即可把电机及反射镜拿出

2. Take out the reflecting motor and reflector by loosening the screws as shown

3.水平放置结构，请注意，反射镜和电机本身就有一定的可旋转范围，水平放置可尽可能的避免安装角度不对

3.Horizontal placement structure, please note that the reflecting mirror and the motor itself have a certain rotational range, horizontally place should avoid incorrect installation angle as much as possible

4.拧掉固定反射镜的螺丝，更换新的反射镜后原样安装

4. Remove the screws holding the reflecting mirror in place, replace it with a new one and install it as it is

更换视频

Replacement video