锐科C系X/H与控制盒的控制接线（中英）注意：1.请确保文中的激光器图示与您使用的激光器为同一型号2.如激光器厂家信号更改，则下列接线失效，请按照厂家提供的定义接线Attention:1. Please ensure that the laser icon in the article is the same model as the laser you are using2. If the laser manufacturer's signal changes, the following wiring fails. Please connect the wiring according t

Switching power supply: abnormal power supply当出现【监测】页面显示不对，且接线没问题的时候，或者开关电源灯闪烁的时候，可以按照这个来处理When the [Monitoring] page is displayed incorrectly, and the wiring is fine, or the switching power supply light flashes, it can be handled according to this.24V供电：主控板.显示屏15V供电：主控板.驱动.电机24V power supply: main

Welding joint problem: abnormal signal of safety lock or trigger button本文适用以下问题表现：①.在不扣动扳机的时候，扳机信号常亮②.在安全地锁未接触到工件时，安全地锁常亮③.没有以上动作的时候，自动出光④安全地锁和扳机信号均不导通This article applies to the following problems:① When the trigger is not pulled, the trigger signal is always on.② When the safety lock does not touc

Welding joint problem handling: no safe ground lock signal.表现： 焊接枪与工件接触时，检测页【安全地锁信号】显示为灰色Performance:When the welding gun contacts the workpiece, the detection page [Safe Lock Signal] is displayed in gray.原因分析： 焊接枪与工件接触时，信号接口一的5/6脚应导通状态，当出现断路或主板内部问题，则显示为灰色，结构如下图Cause analysis:When the welding gun

Welding joint problem handling: gas can't emit light.表现： 焊接状态时，扣动扳机后，出气送丝，红光正常可见，但是不出激光Performance:In the welding state, after pulling the trigger, the gas is vented to feed the wire, and the red light is normally visible, but no laser is emitted.原因分析： 逻辑上，当出气时，出光信号也会发出去的，当激光器未收到出光信号（端口故障）或激光器有问题时