表现:

焊接枪与工件接触时, 检测页 【安全地锁信号】 显示为灰色

Euismod:

Cum autem welding gun contactus in workpiece, et deprehendatur page [tutum signum signo] est proponendum in griseo.

原因分析:

焊接枪与工件接触时, 信号接口一的 5/6 脚应导通状态, 当出现断路或主板内部问题, 则显示为灰色, 结构如下图

Causa Analysis:

Cum autem welding gun in contactu cum workpiece, in 5/6 ACUS signum interface I sit in faciendo statu. Dum aperta circuitu vel internum forsit motherboard, erit ostendi in griseo. In structuram est ostensum est in sequentibus figure.

逻辑

V 脚连到安全地锁夹头, 与工件接触

VI 脚通过三芯线连接到焊接枪枪头

logica

Pin V coniungitur ad salus clausum Chuck et contactus cum workpiece.

Et pin VI connexa ad gun capitis de Welding gun per tres-core filum.

故障处理:

① 同时测试扳机信号是否正常, 个别情况为航空插口松动, 会导致两个信号都没有, 航插位于焊接枪的线往后 80cm 处

②直接短接信号接口一的 5/6 脚, 如导通则主板没问题, 继续下一步的检查

③测量安全地锁夹子到 V 脚的通断

④测量铜嘴到 VI 脚的通断, 个别情况为线断了, 可使用万用表测量信号通断

Troubleshooting:

① simul, test sive trigger signum est normalis. In quibusdam casibus, aviation est solutam, quae non ducere ad duo significationibus. Aviation tabernaculi sita 80cm post welding gun linea.

② recta brevi 5/6 pin signi interface I. Si est coniuncta, motherboard erit denique et continue altera inspectionem.

③ modum in-off de salus clausum clip ad Pin V.

④ mensura in-off de aera COLLUM ad pin VI. In quibusdam casibus, filum contritum est, et multimeter potest ad metimur in-off signum.